Principle and construction of valve hydraulic control valve

Principle and construction of hydraulic control valve

The valve with the above characteristics accelerates in the action close to the valve flap, and is prone to the impact of the water hammer. When the valve is nearly fully closed, the valve moves as slowly as possible, so that a throttle device can be arranged on the valve flap. In addition, the throttling and action parts of the pilot valve should be avoided as much as possible to avoid the clogging. If necessary, add a filter, regularly check and set the bypass line. The hydraulic control valve is divided into two types: diaphragm type and piston type. The working principle is the same. The pressure difference between the above and the downstream is the power. The pilot valve is controlled to make the diaphragm (piston) hydraulic differential operation, which is completely adjusted by hydraulic power, thus making the main The valve flap is fully open or fully closed or in a regulated state.

When the pressure water entering the control chamber above the diaphragm (piston) is discharged to the atmosphere or the downstream low pressure zone, the pressure acting on the lower part of the valve flap and below the diaphragm is greater than the pressure value above, thereby pushing the main valve flap to the full Open position: When the pressure in the control chamber above the diaphragm (piston) is between the inlet pressure and the outlet, the main valve flap is in an adjusted state, and its adjustment position depends on the combination of the needle valve and the pilot valve in the conduit system. Control role.

The pilot valve can open or close its own small valve port by the change of the downstream pressure, thereby changing the pressure value of the control chamber above the diaphragm (piston) and controlling the adjustment position of the main valve flap. Can be used in domestic water supply, fire protection systems and industrial water supply systems.

Classification and characteristics of hydraulic control valves:

According to the structure, the hydraulic control valve can be divided into two types: diaphragm type and piston type. The working principle is the same. Both the above-mentioned downstream pressure difference ΔP is the power, which is controlled by the pilot valve to make the diaphragm (piston) hydraulic differential operation, completely hydraulic. Automatic adjustment so that the main valve disc is fully open or fully closed or in a regulated state.

When the pressure water entering the control chamber above the diaphragm (piston) is discharged to the atmosphere or the downstream low pressure zone, the pressure acting on the bottom of the valve disc and below the diaphragm is greater than the pressure value above, so push the main valve disc to fully open When the pressure water in the control chamber above the diaphragm (piston) cannot be discharged to the atmosphere or the downstream low pressure zone, the pressure acting above the diaphragm (piston) is greater than the pressure below, so the main valve disc will be used. Pressed to the fully closed position; when the pressure in the control chamber above the diaphragm (piston) is between the inlet pressure and the outlet pressure, the main valve disc is in an adjusted state, the adjustment position depends on the needle valve in the catheter system and is adjustable The joint control of the pilot valve. The adjustable pilot valve can open or close its own small valve port by the downstream outlet pressure and change with it, thereby changing the pressure value of the control chamber above the diaphragm (piston) and controlling the adjustment position of the square valve disc.